This mod started as a set of simple clocking blocks, but grew to more than that. And it’s still growing. The clock blocks are still the easiest way to clock a machine, but now there is lots of useful logic to go with it.
Installation
Single Player or Network Client Installation:
- Install Risugami’s ModLoader
- Install SDK’s ModLoaderMp Client Version – Until this updates, use Flan’s Unofficial ModLoaderMp Client Verison for 1.7.3.
- Place the Intergrated Redstone .zip file into your Mods directory.
- A configuration file is created when you run it the first time that will allow you to change the ID used by Integrated Redstone (by default, block ID 116 and item 1004 are used), or to disable the click sounds.
Be aware that V1.4 is incompatible with V1.3!
Parts
To make integrated redstone circuits, you need to start by making parts.
Wafer:
Wire:
Cathode:
Anode:
Pointer:
Integrated Redstone Circuits
Redstone Timer
Sends out a pulse at a user-specified time interval. Powering it stops the clock. Two sides are both input and output, one side is output only, and one side is input only.
Redstone Sequencer
Alternates between each of four sides in sequence at a user-specified speed. Since it is synchronized to world time, it also makes a handy clock – simply set it to 300 seconds.
Pulse Former
Emits a short pulse when the input turns on. The pulse is sent instantaneously, which also makes it useful as a fast repeater, and because the pulse is so short, placing two back to back allows pulses to be sent in both directions.
RS Latch
RS NOR latch. Turning on an input changes state. Turning on both inputs burns it out.
Toggle Latch
Changes state when the input turns on. Can also be clicked to change state manually.
NOR Gate
The output is on when all inputs are off. Can be clicked to disable some inputs.
NAND Gate
The output is off when all inputs are on. Can be clicked to disable some inputs.
AND Gate
The output is on when all inputs are on. Can be clicked to disable some inputs.
OR Gate
The output is on when any input is on. Can be clicked to disable some inputs.
XOR Gate
The output is on when only one of the inputs is on.
XNOR Gate
The output is on when the two inputs match.
NOT Gate
All three outputs are on when the input is off.
Buffer Gate
All three outputs are on when the input is on.
Multiplexer
The center input selects which side input controls the output.
Counter
Counts up by Increment for each pulse on one input, and down by Decrement for each pulse on the other. Clicking opens a GUI to allow the maximum count, increment, and decrement to be set. Each output is on when the pointer reaches the end of range in that direction.
Download Link:
http://www.mediafire.com/?z16o4s03ojcqqes